remote control grab operation skills
Preparation tips before an operation
Inspect equipment: Before using the remote control grab, please be sure to perform a thorough inspection of each lifting component to make sure there is no wear or damage. If any signs of wear are found, the corresponding components should be replaced immediately to avoid malfunctions or safety accidents during operation.
Battery charging: Make sure the battery of the remote control is sufficient. If the battery has not been used for a long time, it should be charged before use. At the same time, batteries that have not been used for a long time should be removed and properly stored.
Safety protection: In order to prevent the grab from decoupling from the crane hook during use, the crane and the hook must have safety protection devices, or directly connect the crane shackle to the grab ring.
During operation tips Remote control operation
Direction control: Use the direction control keys to accurately control the movement direction of the grab and move it near the target position. Speed switching: According to the operation needs, the speed mode of the grab can be switched in time to improve work efficiency and safety. Grab opening and closing: After the grab reaches the designated position, use the grab control keys to open or close the grab. Be careful not to open the grab bucket during feeding to avoid personal injury and material loss.
Material grabbing: Select the appropriate bucket volume: According to the specific gravity and characteristics of the grabbed materials, select the appropriate bucket volume for operation to prevent the danger caused by overloading. Keep it vertical: When grabbing materials, you should try to keep the grab vertical as much as possible to avoid excessive tilt angle, which will cause the middle support beam to produce a large lateral force on the cylinder piston rod, which will affect the performance of the grab.
