How about the container tilter's daily checklist? - Knowledge

Check Category	Check item	Inspection standards/methods
I. Appearance and Mechanics	1. Components	Inspect the main beam, tilting arm, outriggers, etc., for obvious cracks, deformations, or weld breaks.
	2. Twist lock mechanism	Check if the rotary lock is intact, whether the rotation/extension is flexible, and whether there is any wear or cracks.
	3. Hydraulic cylinders and pipelines	Check all cylinders for leaks, ensure pipe joints are secure, and inspect hoses for wear or bulges.
	4. Tires and axles	Check tire pressure/wear and whether the wheel bolts are tight.
II.Hydraulic System	5. Hydraulic oil level	Check the fuel level gauge in the fuel tank to ensure that the fuel level is between the upper and lower marks.
	6. Hydraulic oil status	Observe the color of the oil to see if it is transparent or pale yellow, and whether it is emulsified (whitened) or severely contaminated.
	7. Pumps and Motors	After starting the pump, listen to its running sound; it should be smooth without any sharp noises.
III.Electrical and Control Systems	8. Cables and Connectors	Check the main cable and control cable for damage or exposure, and ensure the connectors are secure.
	9. Control Panel and HMI	Check that the buttons and emergency stop switch are functioning properly, the HMI touchscreen display is clear, and there are no alarms.
	10. Sensors and Limits	Check if the tilt angle sensor and turnlock position sensor signals are normal (HMI display).
	11. Warning device	Test whether the warning lights and buzzers are working properly.
IV, Weighing System	12. Instrument display	After power is applied, the weighing instrument should return to zero normally, and the display should be stable.
	13. Sensor status	Check the HMI or instrument diagnostic menu to ensure that the four weighing points are evenly stressed and that there are no overload or failure alarms from any single sensor.
V,Functional Testing	14. Outrigger lifting	The outriggers are raised and lowered smoothly and synchronously, and lock securely in place once in position.
	15. Twist lock action	Test the locking/unlocking of the rotary locks to confirm that all rotary lock actions are consistent and the signal feedback is correct.
	16. Weighing test	Accuracy verification is performed by placing a known weight (such as a standard weight or a container of known weight), and the error should be within the allowable range.

Inspection Conclusion: □ Everything is normal and ready for operation □ An abnormality was found and requires handling (see remarks)