1. Preparation work
Battery charging: Before using the remote control grab, please ensure that the batteries of the remote control and grab are fully charged. If the battery is not used for a long time, it also needs to be charged regularly to maintain battery life.
Install the battery: Place the battery pack correctly into the battery compartment of the grabber and remote control, and plug in the power plug (if applicable).
Turn on the power: Turn on the power switch of the remote control and wait for some time (such as 1 minute) for the electronic control system to start working normally.
2. Remote control operation
Directional control:
Use the direction control keys on the remote control (usually including the four directions of forward, backward, left and right, and up and down) to control the movement direction of the grab.
Through the remote controller, the grab can be moved to the location where the material needs to be grabbed.
Speed switch:
There are usually single and double-speed switching buttons or similar speed control functions on the remote controller.
According to the operation requirements, select the appropriate speed mode to improve work efficiency or ensure operation accuracy.
Grab control:
Use the grab control keys on the remote control (usually including two keys: opening and closing and lifting) to control the opening and closing and height of the grab.
When you need to grab the material, press the opening and closing buttons to close the grabber; when you need to release the material, press the opening and closing buttons again to open the grabber.
The height of the grab can be adjusted through the lift button to adapt to different operating scenarios.
